Do remember who made the one you bought from O'Reilly?
I know they no longer make the combo fuel/vacuum pump with the glass bowl. So should I go with a Carter, Airtex, Crown or another brand I don't...
Looking to replace the suspension on my '58 CJ5. No lift, just keeping it stock. What's the best package to get and from where? After 60 years,...
I just installed a new solex on my '58 cj5 and it starts with some difficulty always with the choke all the way out. But now there's a dead spot...
Diggerjeep, will your tow bar flip up against the grill so you can drive with it?
Am looking to buy a tow bar for my CJ5 that will flip up when not in use so I don't have to disconnect. Any help?
Battery on my 58 CJ5 will not stay charged. I have pulled the generator and had it checked, and have replaced the voltage regulator twice. All...
I would like to switch to a Petronix ignition and get rid of points once and for all. I have an aftermarket new distributor assembly I bought...
Will bad points cause popping and backfiring? Plugs are ok, fresh gas, carb set right.
Had the same dillemma when I was restoring the engine on my '58. I wasn't going to use vacuum wipers so I installed a fuel pump without those...
I have seen for sale the manual tandem wipers that I believe were made for the MB or CJ3B. Any way, does anyone know if they would fit a 1958 CJ5...
Can anyone tell me how the data plates attach to the starter and generator on an F-134? Both are stock but I don't see any rivet holes if that's...
someone said to put a little mystery oil in the gas tank. My engine is started regularly, but would it hurt to do that?
Am attempting to change the points in my F-134 and was wondering if someone can suggest a simple way to remove the screw that faces the...
anyone know the correct socket size for the oil drain plug on an F-134?
When changing oil on a F-134, what has been found to be the best way to remove the old oil from the oil filter canister? always a pain
No, wasn't much help. Just trying to find a starting point. Someone told me to begin by turning the mixture out two rounds before starting, wait...
Was making a few minor adjustments on my mixture and idle adjustment screws and somehow managed to get the whole thing out of whack. It's a solex...
Have a solex carb on my '58 CJ5. It needs adjusting and was hoping someone could tell me how to start from scratch with idle and mixture screws....
I have a 58 CJ5, all stock. Have read a lot about the pertronix ignition system and wanted to know if it will fit my distributor and, if so, what...
Separate names with a comma.