This seat was in my 2A when I bought it 11 years ago, not stock (for a 2A). Someone thought it belonged to an early 5 or a 3B. Thanks, Rit...
Anybody ever use these thingys? I read Mike Boyink's Dr Vern's ad on Vacuum bleeder pump's and agree, it just sucks air around the bleeder...
Is there a front knuckle lube I can use straight out of the can? What weight and brand? Can I use syn? This is for my 48 2A. Thanks in...
I'm trying to save my hubs but don't care about the drums or studs. How is the best way to remove the lugs? I have a press but it looked as though...
I was trying to free up the rails before mounting the tower and I think I went too far with the rail with the smaller fork. In the rail hole w/o...
Mine's pretty loose in the block, kinda like if I hit a bump it would fly out. Would a new one fit better or is there a trick to make it fit...
Dose this look like a L head air cleaner? [img]
One of my exhaust header studs broke off. You know, let me give it one more turn to make sure. I put a couple of pilot holes in, ofcourse off...
Just wanted to know if most of the guys do it this way rather than buy replacements. Haven't done this in about 30 years. Is there a reason why I...
I screwed around with it for a while last night and nothin'. The old noggin can't remember how it went and the FSM & Early CJ book just don't show...
I was having real problems trying to get the tranny in then found out the ID of the bushing is the same or smaller than the input shaft. How...
Is there an easy way for holding the t/o bearing fork inplace while installing the tranny/bell housing until I get the bell crank on? So...
OK, so I've been racking my slow brain as to the cheapest way to set up a paint booth in my driveway to paint the clip parts and tub. I was going...
I'm just about to hook up the bellhousing to the engine but can't remember where the carrier spring was hooked. That's if I can find the spring...
Just need some advice from experience. Do or should I loosen the caps to get the upper half of the seal out? I have a problem supporting the...
I have a site for anybody who needs different screws, bolts, nuts in different materials and grades. http://www.nuttycompany.com/catindex.html
Where can I find a bracket from the "L" head to the oil filter and return line? I have a bugger welded hand made one on there now. After going...
What is that 1/4" cable that is stretched from the bell housing to the frame with an adjustment nut? Only thing I can figure is some kind of...
My existing tranny a t-box is shot. The tranny I'm swapping in sliding gear is a little rounded, is this too much or is it OK to run? Everything...
Need a Dummy shaft for Dummies I haven't been able to find a dummy alignment shaft anywhere. The only answer I get is they come in the kit (mine...
Separate names with a comma.