All right guys and gals...have a wiring problem. I have finished my resto on a 75 CJ5. Original wiring harness. Dedicated grounds from back to...
Can someone please give me the proper screw size/length that attaches the horn plate to the column. The screws that I have are too long and keep...
Does anyone know where I can buy the retainer clip that holds the parking brake release handle in the bracket on the dash? Can seem to find one....
Does anyone have any pictures, diagrams, or write-ups of which fuse goes in which slot on a 75 CJ-5. The writing on mine is gone and I don't know...
Similar question to one that was recently asked but this is for a 75 CJ. Trying to install the msd ignition and need to know which wire I'm...
So I am in the process of rebuilding my sparton turn signal switch. I have a NOS 4 wire one which I am cannibalizing. The NOS one has the light...
So I have my 75 CJ-5 down to the frame. But...I have found a crack and previous bubba repair on the drivers front. Fortunately its the only one...
I posted this in the restoration forum but got no response...figured I'd try here. Does anyone know what badges came on a 75 CJ-5, V8 and where...
Can some please tell me what badges came on a 75 CJ5, v8 and provide pics of the locations. Thanks.
Does anyone reproduce the sticker that goes on the dash that has the VIN and date built?
Does anyone have any tips for cleaning a wiring harness? I'm rebuilding my 75 CJ5 and about have the body ready for paint. I need to start...
Does anyone know off the top of their heads what the bolt size/length is for a 75 AMC 304 exhaust manifold. I am going back to stock and got new...
Anyone have any tips for removing the seat belt bolts? I got the inner, female ends removed, but the male sides of the seat belts are stuck...
I have a 75 CJ-5 which Im in the process of repairing body rust. I have the body off the frame. I have done most of the mechanical work under the...
Quick question...on my proportioning valve I no longer have the metering valve off the top. The PO just put a bolt in this spot. Question...
Does anyone know if the power steering pulley from an I6 will work on a 304? I cannot find a 304/360 pulley anywhere. Thanks.
Ive been working on my 75 5 but I have a couple of questions. On the dash, I have three cutouts for indicator lights. Looking around it seems that...
Does anyone know where I could find the bracket that holds the parking brake release handle to the dash for a 75 CJ-5? Thanks
I just finished rebuilding my 304. I can get it to turn over and run for a few seconds, but then it dies. I timed it per jeephammers directions,...
So I finally installed my rebuilt 304. Everything was going great until I go to rotate it to TDC. I was able to rotate a couple of turns before it...
Separate names with a comma.