I wanted to show off a few pictures. I have been working on this for about two years. This is my first and I can't wait for my second....
('57 CJ5) I have been working on this jeep now a couple years off and on. It is just how I wanted it too look. The only problem I have are the...
(57" CJ5) My jeep runs no longer. The fuel tank to the pump to the carb is clear and working. Fuel is getting to the carb with no problem. I...
("57 CJ-5) I'm having carb problems. I'm working through it one part at a time. I pulled the fuel pump, one line comes from the fuel tank the...
(57' CJ-5) I am driving along in my jeep. All of a sudden it starts konking out on me. I start it, it does 20 feet or so and it back fires a...
('57 M38a1) I am in the process of painting my jeep. I got the sand paper, paint rollers and thinner. I took the hood off because that is what...
Last parade is over. I would like to now remove 50 years of paint. What is the best way to accomplish this? Take it in and have the whole thing...
Is this fixable? I had to retap the last hole in the engine because the old bolt had sheared off. Unfortunately the drill went on a bit of an...
('57 CJ5 Dana 18 transfer case, T-90 transmission.) O.k. I got everything back together again. One problem, one question: Gears grinding trying to...
I just obtained these lights. They were 24v until I changed out the bulbs. Question is: Is the top light the turn signal and the bottom the...
57' CJ5 w/T90 tranny - Silly question... maybe. Is there a gasket between the bell housing and the transmission? If not do I use a silicon...
("57 CJ5) This may sound dumb. I removed the old exhaust system. It, for the most part broke off in my hands it had so much rust on it. Does...
(1957 CJ5) O.k. so I'm new at this. Now I get it...I think. The hole at the top left (driver's side) of the bell housing is where the cable...
I have a "57 CJ5; Dana 18 t.c. Warner T90 tranny and bell housing. I have them out, rebuilt, cleaned and all pretty looking. Repainted grey;...
O.k. I have read and researched everything I think I ever want to know about this mysterious cable. I don't want to know anything more. From...
Little help please. On my Dana 18 transfer case. I cleaned the rear cap shim set and replaced them. Was there supposed to be a gasket with them...
I have been trying to remove the end yoke from my transfer case. I have WD'd it for two days now and have tried to pull it off using a two-leg...
I have a quick question: I pulled my transfer case on my 57 cj5. If I use aviation permatex do I need to use the the cardboard gaskets? It...
I have one question, it may sound dumb. I'm pulling the transfer case on my '57 CJ5. It is actually seperated from the transmission. My...
First; I have to thank everybody for all the great information. Without you guys I wouldn't know anything about anything. You have all...
Separate names with a comma.