i was looking at the rear floor today i have my work cut out for me. Thanks for the tips guys. I just hope I dont get impatient and screw it up. I...
the welder i'm using is a Northern Equipment 125 from Northern Tools. I did use aluminum plate with the flux core for filling 1/2" holes. It...
if you were to use a tank for 72 and up, isn't it possible to just turn it around so the filler is on the drivers side? The po of my 67 had a rear...
I did switch the polarity, and there are no fans in the garage. The tension on the feed rollers is as tight as it will get, I pretty sure there is...
Hi all. I'm new to mig. I haven't had much trouble with flux core except for burning thru thin stuff. But I'm having a hard time with solid wire...
Krages. www.jeepdoc.com This says for a 134. didnt see anything for 225 (Clutch Fork Pivot Stud Part#: 630068 (16920.21) Model: All 134...
Thanks for the opinions guys. Appreciate it. :beer:
Hey all. I know this has been done to death, but I haven't found anything definitive in the search. I'm converting to 4 wheel disc on my 67 and...
Two words, Hole Saw.
As others have said, the parts are worth more than 300. And don't chuck the trany just because it has water in it. Dump the water out, tear it...
if you don't want to burn the rubber out, you can use a drill and small bit to get most of it out.
Re: Danna 44 axle install John, why don't you try installing the drivers side first. What I mean is, how many shims do you have on the passenger...
you need a rear dump manifold from a 231.
Hey everybody. I tried the hacksaw trick at lunch today. It took me 10 min to press out the center, hack the outer sleeve and pop it out! Piece of...
Patchy I have the same problem with my front bushings. They are stuck to no end. I spent an entire weekend trying to press them out to no evail....
vinyl or cloth? I would prefer cloth myself, for the cold and the heat factor. Nothing worse than climbing onto a vinyl seat that has been in the...
I didn't even consider the other accessories for a 231. All good points. Thanks guys.:beer:
[IMG][IMG]Hey everybody. I started tearing into my 225 today and 2 bad pistons:[IMG][/IMG][/IMG][/IMG][/IMG] If I replace the pistons, I have to...
Is it three between the frame and c/m? Mine has two there and two inside the frame rail(if that makes sense). I too am installing a 2.5" lift....
My 225 isn't hooked up, but the best I can tell is one out of the water pump just past the radiator hose, the other just behind the thermostat on...
Separate names with a comma.