I would like to get this if it is still available please.
Do you use the rubber end gaskets with the RTV or throw them out?
Due to a vacuum leak between the passenger side head and intake on my 225 oddfire I need to replace the intake gaskets. I bought the gasket kit...
Where did you find the 9 7/8" disc for this? Do you have a part number? Let us know how this works out, I have the same engine and tranny, but...
You will be fine, you just need to make sure that when you get your engine at TDC on cylinder #1 the rotor in the distributor will need to point...
So I think you have an odd fire shaft, odd fire pickups, odd fire cap but the aluminum casing I believe is an even fire casing, I had a similar...
The PO installed a foot parking brake which was much longer than the stock cable length and had that cable snaking everywhere under the jeep. I...
I would. The V8 in my truck made that sound right before a rod cap came off going down the road, somehow the bolt backed out a little bit and then...
If I understand you correctly I have a setup similar to yours, here are a couple pictures of mine. The hanging clutch pedal is connected to a...
That write-up was a huge help when fabricating my linkage. There is a wealth of knowledge in the Technical Library... In fact I use it more than...
Here is the clutch linkage I made for the Jeep, which is similar to the AA linkage: on my Jeep blog It was easy to do and is a huge improvement...
If it seems like it is having a hard time turning over then you may have a weak battery which would cause a weaker spark making it hard to start....
If I understand you correctly, when you let off the throttle it backfires, but runs fine idling and accelerating? My 225 with the HEI conversion...
Separate names with a comma.