That was the first thing that entered my mind also!
Judging from the fitment it looks to me like a "halfcab" soft top from an '87-'91 YJ Wrangler with the "Sport Style" rollbar. There are a few...
Here's a link to the CJ-3B page that talks about how to identify the differences in Jeep tailgates over the years. I hope it helps....
Here ya go. A.E. Miller Manufacturing makes a set of fender flares for Flatties http://www.qualitycraftcorp.com/aem/products.htm
If it is still stock, then it will have a Dana 44 rear end. If it is an early '70 model then it will have 19 spline, two piece axle shafts. If...
Now, now Alan. Jeepsters with SOA's don't count in this case! :rotflmao:
X2 on the M38 W/S frame. I don't recall '3A W/S frames having the two vertical straps on them. I thought that the soft top bow sockets...
Nope, won't do much for removing paint unless there is rust under it and the solution has a way to reach the rust under the paint. That's the...
Sammy, I've used electrolysis to clean a lot of parts, and my experience is that it works very well. However, it is pretty much a "line of...
I haven't been able to find any armor, other than sheet metal rear corners, for flatties either. My suggestion would be, especially if you have...
I don't think it matters with the 4.3, but make sure it has the correct oil pan sump. If it has a front sump, then you would most likely have...
If you are referring to the "oil can dent" that flatfender hoods tend to develop, then there is a good article about possible fixes for it on the...
IRRC= If I Recall Correctly Here a link to the Novak site. They should be able to get you set up with the correct parts....
They have a set of two decals for the hubs, as well as a dash decal, listed here: http://www.cj-3a.com/Storefront.htm
Looks like a Dualmatic hub to me. Check out the link for rebuild info. http://www.cj-3a.com/restoring_dualmatic_hubs.htm
Separate names with a comma.
