I'm sorry to have to be asking such a dumb question, but I can't seem to find the answer in either my Chiltons or Haynes manuals. The NOS gasket...
Yeah, I've got all the relavant hardware off the RHD CJ7, including the axle and all the rods. I've noted that when the CJ7 was launched around...
I've got a late ('79 ish) CJ5 LHD which needs extensive renovation work to the body tub. I'm just wondering while I'm at it, could I possibly...
Does any kind person please have a diagram of a late CJ5 soft top frame, preferably with dimensions marked on it? I am attempting to make one...
Cheers guys I didn't know about the shield frame top taper or rake angle being different, so this becomes more of a PITA than I thought....
Could I modify the windshield frame of a late CJ5 to accept a soft top made for an early type? I just found an early one going for a steal, but...
Cheers That has set me thinking about a few cool mods for the Mahindra. In lowering the hood from CJ3B to CJ3A level the rad needs to go down...
Excuse me for butting in but I am in the process of converting an Indian Mahindra CJ3Bto CJ3A spec (body wise anyway) I read before that the M38...
Actually mine is a '77 (if I ever get it finished) so a lot of fittings are CJ7ish
Dumbass question and then maybe not. Is anyone making a replicas of the "jeep" whitco soft tops or is anyone even thinking about making...
Cheers guys. I'm only going to be using the CJ5 for fun and a bit of mild wheeling. My opinion is soft top/snappers + tailgate + swingaway wheel...
I have a '77 CJ5 which I'm rebuilding. A P.O. has cut away the sheet metal either side of where the tailgate would fit (if I had a tailgate...
I'm looking at a new flywheel/ring gear and new clutch from the states as I'm in england and S/H V8 bits are rare and usually more $$$$ than...
I'm pulling apart a CJ7 with the above transmission. I'm toying with the idea of putting it in my '77 CJ5 behind a stock 360. Any good reason it...
The tank don't need to be grounded at all- lots of modern cars have plastic tanks- try to ground one of them! You should be able to get the...
The 1.6 and 2.0 pinto engines were fords bread and butter engines over here. The Cortina 2000E I had would wind up to 110mph on a good day. But...
Cheers Tim. The 90 degree V6 seems to be the one to go for. Enough cubes for some real grunt, but about the right age to be in a hole on...
Cheers! I didn't realise the Iron Duke was popular for flatfenders. I might just find a 1980 CJ7 with one in if I hunt about for a while....
To be more specific. What engine can I get into a low hood flat fender like a CJ2A? Please note that I'm on the wrong side of the pond over...
Before I bought a CJ I'd never had a pedal e-brake. I've found it an absolute pain in the a** on a vehicle with a manual transmission. Four...
Separate names with a comma.