Hello, I have been gone from here for a while, and I am back, looking and thinking about an early CJ5 again. That being said, I am super glad that...
Didn't see this one on search, so here goes: will any of the Postal JEEP windshields fit a top wiper ECJ5 frame? I found several nice windshields...
Will a 4 wire Sparton work for a turn signal controller? I just got two from Pull-A-Part. It doesn't have the integral flasher like my Signal Stat...
On the earlier postal JEEPS, the ones JEEP badged, not AM General, and equipped with the AMC straight six, the heater box is the same as an ECJ5....
Anybody know what size the drain plug on a Dauntless bellhousing is?, or, where I might get one?
I have an opportunity to buy this cheap. I was wondering what year y'all think it is. It seems to have a centered Dana 44. The seller says it is a...
It has been quite a while since I took the :v6: apart and now I cannot remember if this engine uses "exhaust donuts" when connecting the exhaust...
I decided to get some, since I can't find a decent set of OEM.... Which vendor does anyone recommend? :beer:
:) well, after two moves and various other delays, it is beginning to look like a JEEP again. Lots done, lots left to do, but at least it is to...
ok, maybe I am mentally challenged :oops:, but after doing a search, I could not come up with the threads that discuss under tank pads orr...
Most rebuild stuff is done on the chassis, dropped the tub on to start checking for fit. Looks better, but still is a long way off.....:cry:
Need to change pinion seal on my D27, don't have a socket big enough.:oops: anybody know the size required?
anybody know the weight difference between the two? will a Dauntless flywheel work on the 350? any other tips on a swap into an ECJ5?
Any opinions on this? :)
Late & I can't find my service manual :mad:. I need the torque values for T-90 to V-6 bellhousing (has aluminum adapter) and torque values for...
What size are your u-bolts that hold on your springs? 7/16" or 1/2"? Mine were 1/2", but the replacement spring plates I got from a vendor (the...
Can I remove the snubber on the passenger side now that I have installed a 2.5 inch lift? :?
I am contemplating replacing the crossmember on my '70 because it is very cobby. I have looked at the repo ones, seem pretty staightforward,...
(I searched, I promise: I remember seeing something about this but couldn't find it) New BDS 2.5 lift springs, 70 CJ5 w/stock Dana 44 in rear....
All I have to say, after doing spring bushings on my last vehicle by hand, woo-hoo! Habor Freight has these babies on sale and make the...
Separate names with a comma.