It's been a long time since I've posted here. My Jeep's been down with a broke T14 for almost 2 years now. I've found a Ford T18 with the AA...
Yep, I ended up getting the dust cover from a chevy V8 HEI. It bolted right on.
How's the cluster gear look? When my T14 broke teeth off the input gear it also chipped up the cluster gear.
Have you tried adjusting the float level? It could be too high. Sometimes setting one "by the book" just don't work. Maybe put in a different...
I had a similar problem on a Ford truck with a motorcraft 2bbl once. Turns out the carb itself was getting too hot causing the fuel in the bowl to...
My T14 broke and I was not hard on it. Of course I don't know how the PO treated it, but I drove it for 6 months with no problems then one day as...
I'd keep the CJ6 semi-stock and find a cheap YJ for the one ton stuff.
Thanks! Even though my Jeep is a '71 my axles are from a '74.
Oh well, didn't have much luck with this. After cleaning the eccentric in a heated ultrasonic parts washer it looked shiny and clean. As soon as...
I know you said you are swapping in a T18, but Advance has a new adapter for the SM465 to D18 or D20 that allows for clocking the case....
Yep, you're right. I got it off this afternoon and it's defiantly hardened. I'm still going to try repairing it. We have some special welding rods...
x2
It looks like it's cast, I suspect it's not hardened. I was thinking of welding with a high nickle content rod. The weld would be harder than the...
My :v6: fuel pump eccentric has a groove worn in it at the highest point. Would it be possible to repair it by welding up the groove and sanding...
Yep, mine's staked too. Thanks guys for the info, that's just what I needed to know!
I'm getting ready to replace the front seal in my V6. It currently has the rope type seal but I ordered a rubber replacement. Is it as simple as...
Unless I'm mistaken, that shiny piece is the oil seal. I usually screw a sheet metal screw into 'em to get something to hold on to then use that...
Are you sure it's got waggy 44's under it? It looks stock width with aftermarket wheels to me.
That is if you have a Delco dist. I don't think there is a uniset for the Prestolite.
I like what you are doing. Gives me some ideas too...
Separate names with a comma.