I think my low idle screw is missing on my carb linkage. Looks like there is a wide open throttle adjustment on the driver side but on the other...
I pulled some axles tonite and I'm not sure which one to put back in. The one that came out of my jeep has smashed threads on the end so would...
When I left work tonite I noticed some oil on my axle nut. I kicked it and it moved! I could turn it with my fingers. When I got home I looked up...
Has anyone taken a new gas tank (under seat) and had it Rhino lined or coated. Seems like a good idea but wondering if I'm overlooking something.
Hey all, I,m checking a noisey valve train and while adjusting intake valves I found that if I set clearance to .018 on a couple of the valves I...
How often do you adjust your valves? I know the FSM says every thousand miles but wanted to see how often you actually do it. I've got about 2400...
Hey guys I finally got my distributor and module back from Pertronix for the 134. It started right up this time!! When I hooked up the timing...
Are the D25 and D44 from a 61 CJ3b the same spring perch width and angle as a CJ5? Found a set close to home for spares. Thanks
Been having a problem with the jeep since the end of summer. started out just an ocassional problem, be driving along and the fire would just go...
My 134 is starting to have a serious hiccup. Starts okay and doesn't die but will just stop running for a second and then sputter to catch up....
I've been working on this 304 all day. Running crappy,dead spot in the pedal off idle. Looking for vacuum leaks, checking timing, looked at vacuum...
Why can I open the vacume line to the distributor without effecting the idle speed? If I open an unused line on the intake the idle will increase....
Can anybody think of a good reason my dip stick stops about 2 1/2 inches from seating in a 304. It's hitting something tin. Fits in another 304 in...
I'm back again... I've got this '77 with power disk front and 10 inch rear drums. Can anyone tell me if this is the right valve for this setup....
Hey guys, Bought my wife a '77 (because my '59 doesn't go fast enough for her). P O has swapped an '82 or so wide track front axle in and I don't...
Can somebody splain me how you get the washer bent outward over the outer nut?:?
Well I managed to pull the main shaft and input shaft apart and lost the rollers. Is there any way to re stack them without lowering the...
Since I'm waiting on more parts for the transfer case and transmission I tore my shifter apart and decided to put the seal plates on that I saw on...
Hey guys, I'm rebuilding my transfer case and can't get the end play set. I've got the entire shim kit from the Novak kit plus my original .010...
When I pulled the rear driveshaft to start my tranny and transfer rebuilds I could only get three of the flange bolts out , one was spinning...
Separate names with a comma.