I just wanted to address the 12v bypass issue.:)
Here is a pic of a 69 v6 engine pass side view. http://i2.ebayimg.com/05/a/08/99/15/91_4.JPG
Ok I found a good clean pic of a 2g that is off of a truck. The fuel inlet is pointed to the front is different but the location and angle of the...
If you run it too long on 12v the points will get smoked. I fried mine while diag a blown coil. On my 67 cj5 the coil bracket was smaller than the...
eastwood has a gas tank sealer kit. I do not how well it would work with holes in it. After you weld the pin holes up then seal it....
http://partimages2.genpt.com/partimages/493171.jpg Here is the ac delco cap with the window. If it does not look like this it is a prestolite....
On the rochester 2g the vac advance hose goes to the port on the pass side of the carb just below the fuel inlet. This vaccum will not change...
Here is a good question. How do you adjust the float? Get the float drop / shut off numbers from the rebuild sheet. Adjust the shut off and then...
Update: I removed the sheared bolts off of the rear mount today here are the pix. I was able to weld them to a bolt and back them right out. Did...
I checked the links to find some mm and did find a set but they were stock rep. Does anyone know of some polyurthane mounts ava? Or a mod that I...
The balancer on mine was tight and I had to use a puller to get it off. Reinstalling with a installer was habit. To install a balancer with a...
No. I got one from oriley for $126.99 plus $10 core item number A1 30-1693. I also purchased a Accel coil asm for $49.99 item number acc 140003....
Re: Timeing chain advice I would replace it. The asm is considered to last max 50k and repeat process. The post about the puller is right. I did...
http://www.willystech.com/wt/Model18TCase/Model18TransferCase.html section a35e pretty good article. I perused very quickly to find the...
Separate names with a comma.
