I vaguely remember someone on here talking about a possible catastrophic result from leaving out the "pill" which goes between the shift rails but...
It's been a couple of years since I converted mine, so some details are kinda fuzzy. I do remember reading in the instructions about orienting the...
Thanks for the info, but I have already been down that trail with the output shaft. This time it is the intermediate shaft that is leaking.
I hope that this question hasn't been asked a million time on here and my searching skills are just pathetic, but I didn't see this particular...
Congrats, I hope that you are half as happy with yours as I am with mine. I had a similar problem when I first started it up too, it seemed that I...
Thanks to all for all the good information and prompt feedback. This was part of my concern, I couldn't exactly put my finger on it but I got kind...
Is there a way to verify the VIN of a flattie if the VIN tag is missing? Should I give up and keep looking? Background: I have been looking...
Don't forget to look at the other side of the circuit also. Once I had a similar problem and found that a PO had used steel washers to shim the...
In regard to the wire that you were talking about, check out this thread. Toward the end of the first page Phillip-TX includes some excellent...
Another option, Kaiser-Willys sells two different stock height spring packages for the front end one is the heavier duty 10 leaf pack for use with...
When I started messing with my '68 which has at least a similar set up to yours this is exactly what I found. The brittle old cowl gasket would...
Just my opinion, but I think that you will be much happier if you ever have to go back in if you just clean both surfaces completely, and make...
Separate names with a comma.
