Here's some photos of my 1970 you can see the latches on either side [IMG] [IMG]
My 1970 has hood latches on the side. I think they went with whatever the purchasing department got the best buy on.
The costs of conversion will most likely outweigh and savings in gas mileage. Kind of like owning a diesel pickup. You have to be north of...
Would this type of engine have a mechanical fuel pump? Your description leads me to think its the diaphragm in the fuel pump not holding...
I've had the same desire to switch to the SM420 right up until you look at the cost of the adaptor and miscellaneous parts. The SM420's run $75...
I had a similar problem after replacing a clutch and pressure plate in my 1970 cj5. To compound the problem my cj has a SBC V8 so the linkage...
I think Earlycj5.com could become self supporting if it sold just one item. A heavy duty hub puller. R)
What Nick said. Torque the nut to 215 -220 ft-lbs. I found 1/8 NPT barbs and screwed them into my D44 axle vent hole that was located on the...
These guys will fix you up with either a kit, or carb. http://www.thecarburetorshop.com/
I would recommend a pressure test before you complete the install. I've been down this road before using zep and CLR. Both do the job...
I used the aluminum gaskets that Summit sells for headers with good luck.
You can either buy tubing/flare tool/fittings and make your own or most FLAPS have rubber fuel line with swivel ends that will connect. Without a...
Maybe you solved this problem already.......but an easy place to access the wires you need is at the dimmer switch and use a test light to...
Mine sat outside for several years so when the big day came to ad gasoline to the tank I installed a in-line filter near the tank and another...
Compared to my front leafs those are really really flat
Pictures would be nice
A Big hammer to beat on the hub puller center bolt. And when that fails use heat then the Big hammer
Went the teflon tap route on my rear Dana 44. Found like the rest of you my drain plug would keep turning all the way in. No leaks at the plug...
Yes, thanks Walt
Here's my Stewart Warner Speedometer out of my 1970 cj5, odometer works but speed needle does not move. Number along front face perimeter is...
Separate names with a comma.