By chance, does anyone know If the rear wheel openings on a DJ3a differ from a CJ3a in curvature? A few months back, I picked up a set of warrior...
Wasn't sure exactly which forum this should go in, hope this one's fine. I was digging through the pile of parts that came with my donor jeep,...
Getting ready to start a new rendition of my old flat fender again: [IMG] Picked up a donor ECJ5 last night, and plan on using the frame...
Is this actually for a 20, and does anyone have any experience with these?:...
Does anyone know what the max RPM for an l-head should be? I was cruising down the freeway today (which I rarely do) at 3000 rpm's, and it just...
Well, I'm finally tearing into my engine/tranny swap, and have a few questions. I'm going to run a 2.5 mercruiser/sm465 to my existing dana...
Re: Radiator question?? I'm currently working on a 153 Chevy swap. Do you feel the stock l-head radiator will work well enough to keep the 2.5...
For those of you that have completed this swap, or anyone who has experience with this, I'm currently working on swapping my old l head for the...
A few months back, I posted a thread asking about a conversion joint to go from the standard spicer 153x joint, to the small V6 joint found in the...
I was browsing craigslist, and ran into this top near me. It appears as though the jeep in the picture is a flatty, but they're claiming this top...
Well, after searching this site, as well as the web, I've come to the conclusion that there is no bikini top offered for a 3a. Those of you that...
After finishing my bumper, I finally got time to start on my cooler rack. I told everyone I would share when finished. Still working on a way to...
Built a new bumper for my dj today, thought I would share. It is made from 1 1/2" square tube. [IMG] [IMG]
I just got finished with the paint on my jeep, and am now curious about rear hood catches for it. There are holes (which I believe are factory)...
I've run into a problem when swapping my dana 25 out with a dana 27. The yokes on these axles are different sizes, so my original driveshaft will...
Separate names with a comma.