We've all heard the story...."im on a budget"...well I am.. and I was curious if with a 2.5'' suspension lift one needs to replace teh shocks?...
SOOOO.....finally after fighting the windshield glass in, rebuilding the carb as the power valve got screwed up when the engine backfired, and...
sounds good, I will regap the plugs. I was afraid that I may have them gapped to tight for a higher energy ignition. BTW, I bought a carb...
Thanks for the link, I've seen it before. This installation is quite different from that which is required to install a factory glass/seal in a...
Thanks Tim...I'll check that tomorrow. BTW here are some pics of the electronic ignition that has been installed by the PO. [IMG] [IMG]
Finally got it in guys. I have to say that I don't want to do that again anytime soon. It took 3 of us, about 2 hours to fight that glass into...
thanks for the advice. Point taken... Now. Today I had it idling, as best as it could, then I introduced some more air to the mixture, ie..i...
I got the sock in the tank, which is not pushed on all the way, as well as an inline type strainer type filter right before the carb fuel inlet....
Is that a chemical that you dump in the carb? Or is that something that mixes with the gas? I'm a seasoned mechanic, but considering I'm 30,...
I just installed LED taillights and I am now having this problem. Will an electronic flasher fix this, or what kind of load resistor would need...
Finally got all the pieces back together. Now, after getting the engine to fire, it's running pretty rough. Sometimes it will idle fine, others...
Yeah, I gotta give you props. I totally stole the original idea for my jeep from the pics of yours. I love the look your jeep has. It has the...
Thanks, I'll give that a shot, but I'm secretly hoping that Smokeater will come over and gimme a hand with it.
Do you start in a corner first? Seems like I could not find a good place to start.
Yeah, I have been trying to do it alone. The wife's been pretty busy with the newborn, and I was given a hall pass for a few hours. Some help...
Thanks rich, I've actually posted in that thread, but thought I might have better luck starting a new thread. I was hoping to draw out more...
So, for the past 2.5 hours I' ve been trying to install my new windshield glass/seal/locking seal with new as I'm in the process of reassembling...
I started installing the seal yesterday and it appears that I have about a foot of extra seal. Is this thing a fit to cut? It's a replacement...
I painted it outside. Did get a small bit of trash in the clear coat, but I put on a pretty heavy coat of clear so I can buff out the small bits...
I also nabbed some seats out of a 74 for my 72. HOwever, the passenger side seat on mine doesn't line up wiith the catch on the floor. In other...
Separate names with a comma.