does anyone no the width length and height of an early cj hood ?
As it turns out the input shaft of the dodge trans is going to have to be swapped out for a Chevy version, and then I will be able to use a late...
The late nv4500 has a more beefy tail housing and it makes contact with the bearing retainer on the 300 so a ring or spacer is needed .... My...
I already own the dodge version it was too good of a deal to pass up, low miles won't need a rebuild and should mate up to a Dana 300
So I found myself a good deal on a dodge 23 spline nv4500 Has anyone used this transmission with the stock 225 ?
So what year would a vented windshield be found ? I would love to find one that would work with my 66 and Meyer hard top
Any chance you have a diagram for a 66 with a v6
I just like the difference of the short nose, I am going to try my best to keep it that way Once I start building the frame and have the engine...
That's very close, is that a custom rad ? Or did you find a part number somewhere that worked size wise
I will likly go something crate but used, there are a few company's out there that get the engines, do a mild check over of them, build harnesses...
This makes me feel like it's all more doable, do you have any pictures of the grill or firewall ?
I will probably build a whole new chassis
I don't have a year figured out, I guess that is part of my searching, if one year or another is easier then that will be my route to go. As for...
I am thinking about doing an LS swap on my 66 cj6, I have been doing some searching and I have found lots of parts and kits to do it on the later...
Not the driver side, the passenger side folds and then tilts to get to the tool box
I mean I can weld and fab just about anything I might take a look at widening the driver side bucket and just having it re covered
Even though I like the bench and I probably won't easily find another one it's not in the stars for this set, just can't spend that much right now...
you guys are good at convincing
It's on the wrong side of the country for me but that's exactly what I am looking for
I am still learning the site so if this is in the wrong place I apologize but I was at a jeep show today and I saw a 66 cj5 with a front bench...
Separate names with a comma.