I suspect the two are very similar. I have a hanging pedal assembly sittin the garage that I have not installed yet. I was going to start with...
Has anyone used the Advance Adaptors hydraulic clutch kit? I am sick of the chain linkage. When I am all crossed up, the body pulls up far...
Anyone have experience installing the Kentrol Front Roll Bar Kit? Most of the front cages I have seen have the spreader bars bent so that they...
Got it. Reversing them didn't work. Had to grind a little bit. Seems a little loosey goosey once it's all back in the diff housing. The...
Nevermind. I should have done a better online search before I said anything. I found it at therangerstation.com FYI - for anyone else - it's 50...
Anyone have torque specs for Dana 27 front differential bearing cap bolts? None of my manuals list it.
Mike, only you would be able to say "I had a milling machine sitting there." :-) The best I have, however, is a die grinder. So - off to...
Ok - I'm at a stuck point. Carrier is out, Lock-Right is going in. Instructions say to place thrust washers on outside of each driver piece....
Pulled the driver side axle, and tried to do the install in the vehicle. Too difficult to get that d*$# cross shaft set pin out with the carrier...
I've got 3.73's in there, but was hoping maybe I wouldn't have to pull the carrier out at all and could slip the spiders out and slip the...
Wow - that was really weird! I just posted a thread on d27 and lock rights within a few minutes of yours. The Lock-Right unit replaces the...
Wow - it's been a while since I posted! All these new member names - seems like a whole new place! I have searched high and low for a thread...
Separate names with a comma.