I put a "new to me" Weber carb on the 258 and seem to have it adjusted...kind-of. I bought this carb used so it didn't come with a manual or any...
So I recently swapped out the 1 barrel Carter for a two barrel Weber. Got it installed & fired up. It seems to run fine w/ no sputter or backfire....
I just installed a 2" susp lift on the CJ5 and still have a fairly bad lean on the rear driver side, about an inch to inch and a half. It was...
I found a couple of Carter 2 barrel carbs for a 258. They are only $5 each. Would these be good carbs to rebuild & use. I'm not sure which carb I...
Finally got the cage going. I still need to weld in my gussets & do a lower windshield bar but here's what I've got so far. I put a coat of primer...
I'm buying a lift but not sure which size to go with. I can get a 2" or 4" for the same price. Both come complete w/ springs, shocks, boots,...
I've got a 78 Cj5 that seems to have saggy springs...I think. I've had the CJ for about 3 months now and it's always been kind of mushy. It easily...
:( So there I was removing my old, rotten rear cross member to install the big beefy one I fabbed up and realized my body bushing weren't attached...
Anybody runnin an on board welder? I've heard of guys runnin 'em, just wonderin how. I think it's a pretty good idea as we all have or will at...
OK, so I'm goin to install my caster shims (thanks Mcgruff) tomorrow since the weather is going to be warmer...38 deg. woohoo a frickin heat wave....
So...I'm thinkin bout puttin a locker in the front. It's a d30. Any suggestions. Is the d30 able to handle a locker? I'm only running 32's w/...
What's the advantage of using a relay for aux. lights vs. wiring straight to battery w/ an inline fuse? I know this is probably a dumb question...
finished the jack mount today. 1 1/2"x 3/16" angle iron. Copied the hood hinges for the feet & used 1 1/2"x 3/16" square tube for the risers. Lock...
Well it's just about done. Need to figure out an "easy" but strong latch system.[IMG]
[IMG] At the risk of sounding stupid...what is this? A compressor? I didn't think this Jeep came w/ A/C.:?
I need to get a spare tire & rim. How do I measure the backspacing on the rims I have now? I would hate to buy a new rim and have it set in/out...
What's the best way to run a dual battery set-up. I'm definitely no electritian so "dummy terms" are appreciated. Will I need to run a larger...
I need to find out where a guy could get some axle shims for a D-30. I've got some castor angle problems due to lift shackles and was told that a...
found this site. It's got some pretty good illistrations with measurement and good pics. It's for newer TJ's but it's a great reference....
as I stated in my earlier post.... I'm a Jeep Newbie so I may have a bunch of Q's for you all. The Jeep is a '78 CJ5 and I need to know what I...
Separate names with a comma.