I have a CJ2A with original engine. I purchased Herm's kit, knowing there were interference issues with the front plate / motor mount. Modified...
Re: Inexpensive Rear Swaybar Sway bars work fine with leaf springs. Think about what it does. If both wheels are going over a bump equally, the...
I replaced the springs on my 2A with a 1" lift kit. Everything fit fine, except the front end was lower than the rear. I called the supplier who...
Herm the Overdrive Guy lists a cable for the FC to act as the shift mechanism for the Warn Overdrive. Has anyone used one of these or seen one?...
I had a warn overdrive behind a C4 Ford automatic. Generally, I left it in overdrive all of the time on the road. Once in a while I would want...
A couple of datapoints for you. I had a free spinning F-Head that I sold about 18 months ago for $125. My assumption was that it would need a...
Wonder if the PTO winch was a dealer installed item so some got the oak 1" spacer if equipped with PTO. Factory provided the 2 - 1/4" steel...
No, I had no problem selling it. And, I certainly would have liked that synchronized 2 - 3 - 4 on the road. The guy who bought it operates a...
My opinion. I owned a CJ2A with T-90 for many years. I was never a rock climber and in most situations I found that 2nd gear in low range worked...
I have successfully used the nut, bolt and washer method - well lubricated and going slow. I did not use an air wrench as I did the first time...
Where can I find the body armor, rear corners, cross piece that runs under the tailgate, and side plates for a CJ3A? I can find corners, but that...
I had a 1964 CJ5 with factory (I think) T-98 and it had wood spacers, and I believe they were oak. The floor was totally rotted out so I don't...
As said, that is not a factory pump, but is a very common add on for a snow plow. I had one on a 48 pick up for many years. That is so much...
Great point. I am just thinking that I might pick something up when climbing hills on the road at 40 mph. You are right, there are no freebies!!
Do you mean it was off in orientation to the other? In other words, each was not at the appropriate degrees from the other around the...
I have an after market clutch cross shaft on my 3A. The clutch pedal doesn't have as much overall travel as one would expect, i.e. the clutch is...
My thoughts in not using the stock fan are two fold: 1. That fan has to suck up some HP. I see folks trying to figure out how to squeeze out...
Along with the 2 row radiator, I am using a 12" electric fan - 1250 CFM with no shroud. Do I need to add another fan? This is with running the...
I put a 2 row, aftermarket new radiator in my CJ3A project. Is that going to be enough cooling for my old flathead? Reading this thread about 3...
I'm curious. To the fellow who has put a 400 turbo in his CJ2A; did you need to use a 2 piece from driveshaft with carrier bearing over on the...
Separate names with a comma.