I used a 76 and after on my 75. I think I had to drill an extra hole or two. Wasn't bad to install.
Drop me a PM. Just pulled some rubber ones of my 75 to install Xenon Extended units. We can talk.
I made my own for my 75 using a piece of Aluminum angle from Lowes and pull cables from 76 and after Jeep. Some of the cables are a little...
You may want to jack the rear up and check the wheels for play. Side to side and in and out. I had a bad/disintergrated bearing that allowed...
I recently replaced my fuel sender and it has the extra nipple for a return. I am currently running a single-in, single-out fuel filter which I...
After rebuilding my 75 I can say that's better then the norm....Attemp to disassemble the Spartan Assembly-Find screws heavily corroded-Attempt to...
No one to my knowledge makes them. You have to find a used one. I did so locally. Try this guy:...
I have a 75 CJ5 and am looking for the decal that is applied over the stamped Jeep Logo in front of the door openings on each side to make it more...
Thanks guys....Sounds like fabbing up a floor plate will be the biggest fabrication challenge. Would the stock bolt-in tunnel cover be found on...
Santa allowed me to "stumble" across a T18 Wide-Ratio/Dana 20 Combo with a bell housing for $350. It is out of a post 76 Jeep and was behind a...
I thought I asked this months ago, but cannot find it. I am trying to calculate the amount of lift I have between shackle reverseal, 76' Springs,...
4wd.com just started carrying thier own line of AMC HEI Distributors for v-8's $149.99....
I have a "custom" SRS set-up on my 75. But I also have 76 and after springs and hangers. (Thanks to the PO) I actually am very happy with my...
I think it comes down to the counter people more then anything. I do have my preferred brands and go to the local parts store that carries them....
On my 75 it's how far you have the U-joint/yoke assembly slid up on the shaft. There is some play...but that sounds like to much. I would...
I currently debating installing a twin-stick on my Dana 20. The PO "Lincoln Locked" my Dana 30....and until I upgrade to a D44 I was thinking of...
Just took the Jeep for the first drive today after replacing the motor and clutch. I had a heck of a time adjusting the clutch but things worked...
I purchased a new Timing cover/pump and the bypass is not active. Most if not all filters these days come with a bypass valve....
Hello, Try This: http://www.discountjeepparts.com/product_info.php/products_id/13338
On my 75 with a 304/T15 the flywheel had bolt holes for both a 10.5" and 11" clutch. I installed an 11" clutch with little problem, although I...
Separate names with a comma.