I am sorry I would like to post this question on the original thread but unable to find it. My buddy' got a jeep that had been sitting for a...
so what will you be asking for the old 225? will it be up for sale? thanks. I have a buick 350 that I am throwing in on my cj5. Please keep us...
yes I would suspect a 69-68 model. However the windshield is tilted back at an angle and I thought that was for the later years early 70's. mmmm...
the medium pop up garage is on sale at Harborfreight for 159.99 (in my state) here is a pic of it it is fully inclosed too!...
what is a good solvent to clean/soak parts in? I heard some shops use kerosene and brake fluid. (that sounds a bit rough)
WOW. good response! thanks guys, Just what I needed. And Novak offers a SM420 rebuild kit!!! oooohoooo! maybe for X-mass!
Please let me know of a good place to get a rebuild kit for Dana 18 TC and a Warn Overdrive unit. I can get by just replacing the seals,...
I am going to try turning the engine over by hand tomorrow. Its a buick V6 225. guess the best thing to do is do a rebuild. But the P/O said...
My buddy just bought a jeep from someone for $300.00. It dosent run ofcourse. We were taking out the spark plugs when we found one cylinder...
that might be a good idea to change the fluids I would think. Just wondering... are u sure you have the right key? I mean if everything is...
I just had my frame sandblasted with fine sand in my front yard (dirt) for $100.00 even. He did a good job but never trust a sandblaster. He told...
yep! BP blaster is good stuff. I just bought a can 2 weeks ago when I was taking off everything from the frame. The checker auto was out of...
Jeeps lean? wow! I always thought that my jeep and a little swag in its crawl.
Yes! but BDS has a lifetime warranty. NO questions asked when you flatten a spring, twist it or even break it. I am doing a full width sping...
yeah. thanks for the reply. I was looking at them and thinking somebody had to re-weld them or somethign but you could still tell they were...
hahah that looks like the bottom of the parts washer i just bought today! wow!
just got the frame sandblasted today. wow. looks so nice with that silver tint to it. I am looking over the welds and I am pretty sure they are...
well my project is on the ground.. and i mean that! I finally found the time to pull everything off the frame and now she sits there waiting for...
what is the better choice: A pto running off a danna 18 TC or a PTO running off the SM420 transmision. I got a PTO unit that slaps on the...
Sorry if I am wrong on this. but i cracked the input bearing while pulling out the engine. I am not sure if this is what you call it so let me...
Separate names with a comma.