After I pulled the 401 out of a 79 full size, I replaced it with a 304 from my buddies 360 swap in his CJ. Got the full size running with the 304...
Yes, the 360 and 401 V8s that went in the Wagoneers used a deeper block mount then the 304 V8 used in the CJ. You need BOTH the frame and...
wohh, wait a second, there was a self cancelling unit? This is all I've seen on the 75 CJs and you have to turn them off yourself. I thought it...
# 4. Compare the 77 tub mounts and frame and you'll see the post 75 frames are wider in the rear. So keeping the axles with the 77, you'll save...
I always use OEM wiring harness or buy a good (uncut) used one. I know they are old, but I haven't seen an aftermarket one with truely the correct...
If you still want "a List", then this is how I put CJs together. This assumes that all components are competed and ready for install (like axles...
Since the CJ-6 fiberglass tub was made to go on a CJ-6 frame. I would reference that to the CJ-8 frame....meaning the differences in the frames....
I thought it odd to have the extra room and only be able to access it from over the tub rails. Here's a link to a Red 74 6 with a 304 and the...
My 75 does not have the tailgate (yes, original body) and I wish I did have the gate at times. Most of the CJ-6s I see DO have it, so I guess that...
I was going to switch the center stud between the too when I did my swap, but read that the 4.0 doesn't have the same anti drain as the 4.2, but...
The P.O. installed this and although I had a OEM 75 CJ-5 roll bar, I retianed this for now as I didn't want to drill even more holes to install...
OK...so that IS stock....I have one too and thought the P.O. rigged something in for the seat.
Toying around with swapping in a set of 82 to 86 widetracs in my 75 CJ for several reasons. 1. Instant disk brakes 2. I really like the looks of...
Im thinking that if the U bolts are good and tight, the clamping force is focused between the flat perch bottom and the area of the flat spring...
When doing a 304 swap in in 75, I learned that the 6 cyl frame bracket had a different bolt hole spacing (to the frame) for the pre 75 as did the...
Yeah...don't know who I got it from, but I save every chart or pic I come across to keep the sharing going...thanks goes out to you, and all that...
I have a 75 (same as your 74) and will be taking the body off in a few weeks. What measurments are you needing or is it something I can measure...
Wow....OK....lets start over......Someone got the wrong impression and I am not a newbe . I have been into Jeeps for 19 years. I currently own 2...
When comparing my 75 CJ-6 to my other late model CJs, it drives like a high speed farm tractor. It had a 258/T-14/dana 20 that I swapped over to a...
When adding tube fenders, its the inner part that is cut out and joined to the tube framework. So yes, the 72 to 86 CJ tube fender will be the...
Separate names with a comma.