I am rebuilding a '46 CJ2A. I am putting a Dauntless V6 in it. I want to keep the stock Ross steering setup but the end of the drag link hits the...
Does it matter which end is front and which is back? Doesn't look like there is any difference in the shaft bends and Service Manual says no...
I am rebuilding a '46 CJ2A. I was going to put Dauntless V6 in it. I have V6 motor mounts welded in frame. I thought I read somewhere that I...
Does anyone have picture to show how/where the flexible rubber front brake hoses (right and left) attach to the frame? I think my frame must be...
What lube should i use in the Ross steering box of 66 Cj5? There is fill "plug" on the box that makes me think something that pours e.g...
I'm looking for good rebuild guide for the Ross Box steeering in a 66 CJ5 with V6 engine. Also, what gear lub should I use in the steering box?...
I'm reassembling the front end. Are the tie rods supposed to be level or angled up to the bellcrank? Mine are about 3.5" higher in the centre...
For 66 CJ5 the adjusters are left-hand thread and right-hand thread. Do the LH thread go on the left side (passenger) and the RH on the right...
I am reassembling 66 CJ5 10" drum brakes. Two adjuster barrels are right-hand thread and two are left hand thread. Which ones go on which...
I've removed the entire drive train from my 66CJ5, 225 V6. I am now reinstalling the entire drive train (axles, trans/TC, motor). Everything...
I'm putting the drive train from a 66 CJ5 (225,T86, Dana 18 single stick) into my 46 Cj2A. I want to keep the transfer case twin sticks from the...
I have a 66 CJ with 225 V6 and manual transmission. Does anyone have a good picture (or dimensions) of the transmission to cross member mount? I...
Where the splined driveshaft goes into the driveshaft yoke there is a dust cap. How do I get it off? Is it threaded on/off or just pushed on/off?
Which better cork or rubber? Why?
I have a 66 CJ5 with dana 27 front and dana 44 rear axles. I am replacing the leaf springs. When I took out the old springs I cut off the 'U'...
Dana 44 tappered rear axle - my Chiltons manual doesn't say anything about how tight the rear axle shaft nut should be and my Haynes manual says...
Walcks has 2 options - one american made, one foriegn made. Has anyone had any good or bad experiences with replacement springs? Other than...
For Dana 27 front axle my Chilton manual says SAE140,GL3 knuckle lube. I can't find a straight 140 lube but I have some 85W140. Are they both...
I am installing new kingpin bearings in my 66 CJ5 Dana 27A axle. What is the correct torque on the bolts and should the bearings be packed with...
Can I replace my AMC 360 with another engine that will fit in exactly where the AMC 360 came out (i.e same motor mount location and transmission...
Separate names with a comma.