order from herm the overdrive guy. I order his kit to vancouver island and no issues.
I used the all steel one as well. I got it off ebay and it bolted right up to my 225 no problem. I then got a Saginaw box from a 1991 jeep yj...
I used a 1" lift puck from MORE off road and a 1/2" poly mount from kaiser willys. It gave me the lift I needed to run 33" tires.
I used herms dual master cylinder kit and r&p disc brake conversion front and rear. When I did mine I used a mc that was specific for disc...
Hi has anyone installed a neutral safety switch with the t90 ? had a close call with my willys when I started it and didn't know it was in reverse...
Hi all, this may have been asked before but what throttle cables are people using for their swap? I have the 225 with a Rochester 2g carb. The...
Hi, all I have a flattie with the 225 in it. And I need to run the gas pedal linkage to the carb and would like to keep the original gas pedal....
Joe, it looks like it started out life as an MB. Some of the indications are the rear tool boxes in the fenders and the hole in the seat frame...
oh ya, depending on your engine you may need a heat shield. I have the 225 with a 231 rear dump exhuast manifold and my brake lines are quite...
I have used Herm's kit on my 43 GPW. I had several issues but nothing major. The Stock GPW frames are boxed in the brake location so I had to...
Thanks Windyhill, if you don't mind maybe I can send you some pictures once I get things mocked up, to see it you can spot any issues before I...
Thanks Windyhill for the photo tip it seems to have worked out. Here is a link to some photos of my swap. Still working on the steering conversion...
I have sourced a saginaw box from a yj and think I will go that route. I think I can make it working going under the GPW front cross member with...
Vintage Jeeper, I can send you some pictures of how my conversion is configured and where my engine mounts are. My conversion was done with a...
Hi everybody, I have read everything I can see on possible steering conversions for my flatty (1943 GPW). I have a buick v6 conversion and a...
I have a Holly Street Dominator Intake that I am not using and would part with. However, I am located in Canada :( I would post a picture if I...
Hi, I finally got my V6 back into the frame, however, is there a way to test the clutch assembly to make sure everything is working properly...
Herm the overdrive guy makes a bolt on kit that goes between the frame rails and behind the rad. Depending on your engine setup this might buy...
Hi, I have bought a 1943 Willys GPW with a swapped in Buick odd fire V6. As I am putting back together I am finding I have alot of questions....
Thanks for the reply, here is a picture of the bellhosuing would the 72 boot fit it or the A/A one. Thanks [IMG]
Separate names with a comma.