Alright, well these studs seem to be working. The splines are only cut partway down the shoulder, so the splines only have engagement about 40% of...
Alright... I found some similar studs that might work. The knurl diameter is .667" which might be perfect for a tight fit. My holes were...
Alright, so I'm doing the disc swap in my '69... I go to press the hub/disc assembly together and the stud splines won't engage in the hub. You...
I am currently in the process of designing a york compressor bracket for the 225, as well as a front air tank bumper in Inventor '08. i also have...
Alright, here's my situation. When I let the clutch out to take off from a stop, the whole rig will shudder. It will do this the first few...
Okay, so I'm curious if anyone out there makes (or ever made in the past) a secondary alternator bracket for the 225. I've seen them on SBC's...
bump for new info
Back in December, the Jeep's motor bent a couple valves, and I recently got it back together with rebuilt heads and the rig is running a bit...
try tightening up the bellcrank and/or replacing the bearings in it. i couldn't really understand what you're trying to say when you explain what...
Clutch throwout bearing? Mine makes a lot of noise in neutral with the clutch out. it makes an intermittent clunking noise with a more consistent...
Yeah, yeah... The 225 is supposed to idle rough. how rough is normal? Is it supposed to shake the entire rig? Is it supposed to be a heavy and...
Separate names with a comma.