I'd try electrolytic rust removal. Fill the cylinders with a solution consisting of 1Tbsp "Washing soda"(Not baking soda) to 1 gallon water. Hook...
If you're talking about the engine stay cable (Look at http://www.cj3a.info/tech/stay.html) Should deflect 1/2" under "thumb pressure".
Thanks napaguy, The trouble spots I've listed are all I found on a careful survey of the entire frame. The front 60% of the frame was protected...
Getting ready to wire wheel and paint the frame on my cj5 I've gone around the frame and run across a couple of damaged areas that might or might...
Yup, on closer inspection today, turns out that's part of the part #CJP 740 A 10W.
While pulling the engine off my '64 cj5 (ALL RIGHT! down to the frame!) I noticed the Prestone Generator on my F-head listed 10W as it's output...
Sorry to revive an old thread, just wanted to point out an updated link for Howard's WhirlyJig as the old link is broken. Thought this might help...
Like W3SRL said velocity. It supports turbulence and better mixing. You don't want turbulence on the exhaust path but on the intake any mixing...
If this isn't the correct place please move me mods. My '64 is getting a D30 with 1-1/8" thick rotors (which I picked up for a $Jackson :))....
I bet the two upper holes might be enough. You're welcome, no problem!:stout:
Actually, now that I think about it..... The idle mixture screw is probably what you want. It's at the base of the carb under the choke. If you...
Checked your float level?
Separate names with a comma.