Anyone have any pictures of the frame of a 74 Cj-5,,, Iv driven this thing 18 years with the same 304 in her,, The hard top was holding the body...
Im planing on using my hanging pedals from my 74 CJ-5 on my CJ-3B body swap ,, So I should check to see if the springs are in place & if they are...
But where was the charcoal canaster mounted ,, My 74 was a real rusted up mess ,, it fell apart as I took the hard top off...
I am installing a 59 Willys CJ -3b body on a 74 Cj-5 frame & sure could use the pictures of the fender well baffles.. I need to add a rollover...
Well Im not using a XJ collium butt I am using a S10 chevy truck tilt collium ,, Im installing a 59 CJ3b body on my 74 frame I liked the ides of...
I bought a ez wire harness for my 74 with a AMC V8 & told them I had a S-10 tilt column & needed the wirng for that & it came with everything I...
Ditto on the sun pro ... Easy hook up,,, Wow thats a nice looking Cj I dont think mine looked that good from the factory,,,
Back in the early 70s I had a 64 Willys truck with a t18 tranny in her ,, sloppy wasnt the word for it ,, I pulled the top off & braised some...
See what you JEEP is doing with or with out the Overdrive,,, Any kind of gear ratio before you turn wrenchs & change tires,, Guess you have to...
I've got a 74 CJ ,, When I bought it the PO put bondo on the angle at the very bottom of the roll bar ,,, After a screw driver & a hammer I found...
Anyone ever use Never Seize,, I just put a dab on the end of the shaft & it lubes good & dosent get hard or brake down from any friction heat,,,...
After looking closer at mine I figured out whats wrong ,,, The cotter key that I pulled out only had one leg on it ,, Picked a needle nose vise...
Thanks a bunch I was just about to go out & get a bigger hammer,,, I pulled the cotter key already ,,,, Ill give it a shot ,,,
Separate names with a comma.