I used the stock skid plate with the 21 gal poly. You have to do a little fabricating when it comes to the tank strap. I just welded a couple of...
Changed over to a 21 gal poly. Wasnt sure if I was going to like it but I do. Less time at the pump and a little more weight on the back end....
I switched to a flaming river tilt column. It wasnt to difficult to install but I made a custom dash so I am not sure about installation on the...
Was I supposed to take the distributor out before working on back-up lights? I thought just taking the negative off the battery would suffice......
Ok. I am lost. I was installing some back up lights yesterday. I pulled the negative off of the battery then put it back on to check for power...
Thanks. Got em working!
Thanks Hudson and Timgr for the quick reply. I will definately trace that hot wire.
I am by no means even an amatuer at electrical so this may be a stupid question. I finally got my rear bumper/tire carrier done and I am working...
I could never find the round plugs for my '74. Repro at least. You can always check junkyards. I ended up using tweeters that I bought at Best...
I have the stock fuel sending unit hooked up but I think that is the problem. I am looking for the tube type now. I am replacing the tank with a...
Wasnt concerned... I have Equus gauges and my fuel gauge needle bounces all around when off road just thought it might help with that. Not a big...
Has anyone seen these foam cubes to put in a gas tank to prevent sloshing? I was thinking about trying them but I wasnt sure how the fuel sending...
Separate names with a comma.