Saweeet!!! Good looking jeep!
what i do is take a nut a size or two larger than the broken bolt and weld it to the bolt, even if it broken flush or slightly lower. The welding...
I have tore down a lot of engines and have never seen one where the inside of the valve covers are dry like that. I don't think there was any oil...
Another way to hold the valves closed while you remove the springs is to pull the spark plug and feed some 1/4 inch rope in the cylinder and turn...
Just borrow a GPS from someone, they show speed pretty accurately.
If it runs then dies, check for spark. Sounds like a bad coil to me, because it fired up after it had a chance to cool down. Hope this helps.
Man, thats one short driveshaft!R)
I have the cutlas hubs on my jeep as well, easy to turn and have never given me a but of trouble. BTW - very nice jeep you have there!
I've dealt with Herm, and can say that the items I got from him (parts for a husky overdrive) were top notch, and he was great to deal with. Very...
If you are going to get replacement springs, go with 2.5". I did and don't regret it at all. I will try to post some pics when I get home.
That simply rocks. Very impressive.
I would really recommend pulling the pan and having a peek at the bearings. You don't need to pull them all, just a couple of mains and a couple...
Go for it. I only have 33's, but have never had any issue's. As for upgrading the axle, just run the 27, and THEN if you have trouble swap it out....
231 water pump it is! Thanks for the help, this sure had me scratching my head. Guess sometime in the past it had been switched over. Ahh,...
Warloch - That would be great if you get the measuments for me.
Separate names with a comma.
