My 78 has the baffle on both sides. They are identical. The indent is for the hat channel on the right side that supports the side mounted spare.
Thanks for the advice Tim I think I will just let them do it.
Tim I have some left handed bolt extractors somewhere if I can find them. They were my dads. I am going to pull the head off. I figure after 30...
Thats what i thought Tim. The FSM shows a stud in that hold and a bolt in the most rear hole. The bolt was fine but the stud as you can see is...
The weather has been cold again here lately so I decided to tear up something else than the chassis for a while. I took the alternator, air pump,...
Sorry Gerald, I didn't know that. Please ignore everything I posted and forgive me.
According to the 78 FSM which should apply to Wuze's 79 as well since the drivetrain is the same, the Jeep people of the time recommended you do...
Looking at Wuze's profile, he has a Model 20 transfer case, since his CJ6 is a 1979 export model.
If you need anymore let me know. I can also dig out my pedals and column and master cylinder if you need any pictures of anything else.
From the bottom of the hood drip rail to the top of the master cylinder hole is slightly less than 3 1/4 inches
Check out this link and go to the last section marker CJ-5 Rear Seat. It shows the factory setup for an intermediate CJ5....
If it is an intermediate, the rear seat will have pins that hold it into the mounts if it is factory. Take the rear seat and mounts out of the 72....
There was also a painted steel rear step bumper available on the intermediate CJ5's as well. I've never seen one but it's shown in the special...
The CJ3B page has a section on windshield wipers that talks about the electric motors. Not sure if it would help with what your doing but here it...
Pete I think they may have changed wheel sizes in 76 when front disk brakes became an option. Tim would know for sure.
Separate names with a comma.
