Thanks for all the replys. Trying to avoid an axel swap the pow ran 35x14.5 in the woods for a long time I am doing a frame off restore on a...
It a 68 with d27 on front and a 44 offset rear it has been in the woods on 35's x12.5 since. 1981 and only broke one axel shaft. Anyway I want to...
I would like to keep a 35" tire but get one not so wide (having issues with rubbing springs )with the 35x12.5 x 15 tires, was hoping for a 17 or...
Is there any measurement to check on a Dana 27 king pin race or just the obvious (scratches)?
Any one that can answer my questions on the Yukon kits would be greatly appreciated. I really want to get the correct one ordered as soon as...
Thanks, it had 35's on it when I bought it and it drove like a nightmare, on my other post u could c the bent tie rod, sagana gone wrong and other...
[IMG]
I took my Dana 27 apart to install R&P front disk kit, this is what I found upon inspection: I took apart the knuckles to install new seals...
relocation is complete see my post 3rd one could be a charm.
[IMG] [IMG]
looks ike the body will clear but not by much [IMG]
[IMG] [IMG] 1 1/2" between shackel mounts and skid plate [IMG]
started to mock up 78 cj gas tank out back [IMG][IMG] [IMG]
removed trans and rest of drive line, just persuaded hitch assembly off. [IMG]
pulled motor out [IMG]
removed gas tank seats and roll cage [IMG] body comes off afetr much persuasion from cutting wheel and sawzall! [IMG] [IMG] [IMG] [IMG]...
Need to reaserch what a good donor car is for a 4barrel I can rebuild, thinking it will probably have to be late 60's early 70's.any suggestions...
Separate names with a comma.