My '79 got a used engine from the auto guys. It has the number: 105C18 or 105018 stamped on a flat area on the passenger side of the...
My '79 with the 258 appears to be running real rich. I have adjusted the carb, changed plugs and wires and no change. It was suggested by a...
I have a friend with a '71 postal Jeep that he would like to convert it to 4 wheel drive. He is running a '74 232 ci straight six in it now. No...
Hi All, My '68 speedo is making a real squealing noise when hooked up. Disconnected, the new speedo cable is working fine. Is there anyway to...
My '78 has some really trashed spring plates that the ubolts go into. The plates have 2 protruding studs, one for the shock and one for the...
Hi Guys, When removing the steering box to weld the broken bracket, I had to cut off the rear bolt to the bracket on the drivers side to the...
Hi Guys, I have an AGR2 steering box on my '78. Has anyone ever built the bracket that goes from the box across to the opposite side for...
Hi Guys, Finally got around to putting the shims on the front springs to correct the caster angle. Need to know, FOR SURE, that the fat end of...
Hi Guys, Happy New Year. Was driving the '78, 304 stock down the street and bang, the rear yoke connected to the xfer case broke. That's the...
Hi Guys, It appears the back seat on the '78 is a fold and tumble type. However, the PO has bolted the back of the seat to the floor as tho it...
Hi guys, Anyone know where I can get the hose from the heater box to the defroster plenum on the West Coast? This would be for the '78.
Hi Guys, I have the Sparton on the '68. Works fine, but will not return to neutral. Does anyone know where I can get a new wheel,the one that...
Hi Guys, I know my fuel gauge is shot on the '78 CJ5. It is the standard SW guage. My '79 CJ7, however, is strange. Instead of the 3 terms...
Pulled the housing that holds the speedo gear after pulling the brake assm off the '68 T14A/D18 today. Reason was there was no oil in tranny and...
OK. I searched and have found the weight of a :v6: is from 380# to 420#. The T14A is about 90# to 110#. Are these numbers close? Need to ship...
Hi all, Need new motor mounts for the '68 with a :v6:. Any ideas where I can get them? Can't seem to find them anywhere. :oops:
Hi Guys, Where do you take your block to have it hot tanked? Where do you get your valve job done? Need to do these things to my V6....
HI Guys, Next is the removal of the Ross steering box. Looks like a clamp at the top of the box and a couple of bolts. OR do I have to pull...
Hi Guys, Taking out the '68 V6 for rebuild. What is your opinion of where to disconnect the trans from engine. At block or at Bell Housing? :?
My buddy Ernie would like to know if a CJ7 hood from a '79 will fit on his '76 CJ5. Any takers? :?
Separate names with a comma.