I purchased a used adaptor for a dana 18/20. I thought that my transfer case was had a 4 inch bore because of the 10 spline input gear. But found...
I have a dana 30 with disc brakes that I got from a junk yard about 2 years ago. I am almost done with everything for my swap. The question I...
I am installing a rear tank with skid plate is there something that goes between the tank and the skid plate? Like a rubber pad or does the tank...
I am getting ready to rebuild my 79 buick 231 engine. But I have been looking at buying one of these reman engines. The one that I am looking at...
Where is the best place to buy castor shims and leaf spring center pins? I found some on ebay but not sure if they are steel or aluminum....
MY title and vin# put this jeep as a 70 built in 69. But the body I think might have been off of a latter model. It has swing pedals with cluth...
I did a search and was unable to locate any torque specs for 1/2" U-bolts and shackle/spring bolts. The two manuals I have (non-factory of...
I am installing all my 70 parts in to a 68 frame. My question is do I need to remove the v shaped part of the rear frame in order to get the tank...
I am putting a dana 30 from a early 80's cj7 into my jeep. The u-bolts that came with my lift are to big for the spring plates, and the old plates...
Separate names with a comma.