Ya I designed it and a friend of mine made it
Sheet metal almost all done
Lol ya since it was a diesel had to throw a little truck spin on it :)
Ya the driveshaft isn't super long but with the spring over done it won't be as bad as a person would think
I can still get full tuck with the way we are building the flares..I just don't care for a cut off back look and can make my suspension tuck after...
We've spent about 2 years building a flatfender 4BT... Why two years? Cuz 4 kids and life that's why lol and other Jeep builds in between.. Why a...
Hi Nick been a while since I've been on here been busy with life...I'm looking for a front 44 set up or matching set to put under a flatty.. I had...
Willys Overland in Toledo gets the same Omix Tubs but then they take them and make all the neccessary modifiacations to fit correctly. They cost a...
Yes they will but still will be a little wide. I personally take old truck tonnau covers that people are selling and cut them to the length and...
Are the FJ40 rubber blocks or hard plastic?
I like your idea of the fender wells since you have wider axles anyway. That will gain you a lot of interior room
Looking for something original for the hood blocks. My uncles used wooden dowels in the 80's. I have used original wood blocks with pipe...
Still havent said excatly how it happened.... 4500 rpms and jumping rocks might do it R)
Not to jump on your thread...but sounds like your questions were answered and somewhat same topic. I just got another flattie a month ago and the...
So are there still heads out there available?
Just finishing up the one in my 52 M38A1 and w/ small block and overdrive. Salivating, imo best bang for your buck for durability, size and low...
Thanks guys, Scott really was just worried about quality more than the capacity but I think Warloch helped to ease my mind
I know wilwood has been discussed here before but I am leaning hard to buy one for my hydraulic clutch setup and was just wandering opinions of if...
Ordered the carb. I will give an update when it gets here and I get it slapped on
Do you think a pull cylinder would be a more simple solution or this route?
Separate names with a comma.