Hopefully a simple question. How the crap am I supposed to make my m38a1 street legal---with tail lights, when there is a giant spare tire on one...
Just switching out my 1954 M38A1 electrical system from 24 V to 12 V and I would like to keep the original instrument panel. Any ideas as to where...
As I went to clean my fuel pump the only thing on my mind was not to break the glass globe. And that's exactly what happened. Perhaps the only...
I have just about pulled my hair out searching for a dang frame bushing that the front shackle screws into. Everyone I've talked to thinks I'm...
I forgot... as far as the gauges go I'm stil looking for origonal looking 12v gauges. cant find them. Is there anyway I can reuse the 24 volt...
Well, its not exactly as bad as it sounds...I stole the altnerator, distributor, sylenoid, coil and starter from my 57 cj5 parts jeep and put it...
great with all your sucsess stories it gives me hope! How did you guys know which wires were what on the digrams?
I'm converting my m38a1 to 12 volt from 24. Got all the electrical system from a 57 cj5 and have installed it. Now I'm just tyring to do all the...
ok, so how the heck do I get the old ones out?
I'm currently changing out all the suspension on my 54 m38a1. I've got the springs rearched and new shocks. However the front bushings in the...
Looking for parts is a never ending story...especially when you have hardly anything to work with from the getgo. That at least is how it is for...
So bondo has to be the most contriversial item since evolution was created. I am getting so sick of people telling me its good, its bad its good...
I want to get some diamond plate corners but can only find some for a cj7 or yj. do you think they'd work for my m38a1?
Ok, I cant figure it out. I've got a 54' m38a1 that sits crooked. The drivers side is about 2 inches lower then the passenger side. I got under...
does anyone know where I can get a wiring harnes diagram for a cj5 or m38a1???
kieth, well, not really. I'm not keeping it for origonalities sake, but I would like to keep it as cheap as possible and buying a new starter, etc...
Ok, so I ordered a wiring harness from ez wiring (ez 20 mini) then I got to thinking, will it work for a 24 volt? they dont seem to know so I...
Ok, so I've asked similar questions before but here goes again. Bare with me... i am a beginner :) :) I am in the proces of looking for a...
I'm working on my 54' m38a1 and discovered a bracket on the passenger side body (inside) and am very curious to know what it is... My best guess...
Thanks a lot for your help!
Separate names with a comma.