1971 CJ5, 225 oddfire, I just pulled the jeep out to get it ready for hunting. It started right up and I shut it down. After about a half an hour...
1971 Jeep CJ5, 225 V-6, I am trying to manufacture a new exhaust pipe using flowmaster mufflers. My jeep has headers and it is currently pieced...
1971 CJ5, V-6 225. I am replacing my master cylinder. I took the old push rod from the old one and converted it to the new one which was a task in...
When I jack the rear wheels and spin the wheels and apply the brake the tires initially brake for a second and stops the spinning wheel. After a...
I pulled the drum off one side (back) and applied brake pressure and the pads expanded like they were supposed to. When I put the drum on and...
When I bled the rears I got fluid from both rear wheel cylinders. Nothing seemed abnormal.
1971 CJ5, 225 V-6, drum brakes all around. My problem is that the jeep pulls to the drivers side when I apply the brake. I changed the pads and...
1971 CJ5 225 oddfire engine. I installed a HEI aftermarket distributor about a year ago with no problems. The problem know that I am having is...
I am still confused. Do I mount the clutch housing, throwout bearing and clutch fork to the transmission first prior to lifting the whole unit...
1971 CJ5, 225 V-6. T-14 Transmission. I am trying to install a rebuilt transmission and transfer case. I did not remove them from the vehicle. I...
Thanks for all the info. I think the bottom line is that the trailer is to small. It is better to air on the side of caution instead of hurting...
The trailer has been reinforced, the axles have been distributed right, wheels and tires and springs are rated for the proper weight of trailer...
The weight was distributed over the trailer with the proper tongue weight. The frame of the jeep was straped to the trailer. I am wondering if...
I have a 5'X10" trailer that I beefed up and put two new 3500Lb axles with 13 inch wheels on it thinking this would be the perfect little trailer...
I have a 71 CJ5 with a HEI distributor. Plug gap set at .045 and 6 degrees before TDC. The jeep runs good but I get a popping sound out of...
Right know I have one hot wire going to the brake pressure switch and the other going back to the rear lights. I have an add on power steering...
!971 Jeep CJ5 V-6, I am trying to wire the tail light on the old Jeep. All the lights work except when I try to hook up the hot wire from the...
I have a 71 CJ5 that has had power steering added. I don't know what year or model the power steering is. The steeing wheel and inner shaft pull...
How hard is it to change the intermediate shaft and bearings? Is it hard to get the parts? Does the transfer case need to be droped? How much...
I put her on jack stands and put her in gear and put a load on her with the emergency brake and the noise got louder. Any suggestions Thanks Lee
Separate names with a comma.