I paid 2k for my '66 4 years ago, and it's been nothing but surprises the whole time. Good and bad. In retrospect, I wish someone had talked me...
200hp sounds good to me! Good advice, it gives me something to plan while laying awake in bed, miles away from my Jeep. Still have to get it put...
Anyone try using the larger 2gc 2-barrel rochester on their stock intakes? There are a couple mid-60's and mid 70's models out there that have 298...
"You don't say what your needs are for this motor so it's hard to give advice." Occasional trail rig / daily driver... Low budget build, if...
I *think* the 231 manifolds are both passenger side manifolds, with one side exiting from the front and the other exiting from the rear...
While aquiring a replacement bellhousing, I also aquired the motor attached to it (thanks Gemini). It is an even-fire 231, and my current project...
Wait... what? Come on over! I only need one! ;) Seriously, the wreckers here are not very friendly nowadays. I called about a bop bellhousing...
I fully understand it is an adapted bell-housing, I took nickmills advice that it "looked like a stock cj". My research shows that this was in...
number on the adaptor reads "aa cj 509," can't find it on their website...
Yes it is an adaptor. It has 4 bolts on the outside, and four smaller allen key style fasteners surrounding the hole for the output shaft that...
Whoah got ahead of myself, better get the bell off first. This is of course the whole reason behind removing the transmission in the first place!...
Right right, I meant pressure plate, not the flywheel. Thanks for the reply. Heading up the hill now. ~w
Gonna try to get the clutch out today at lunch. Will it come out pretty easy once I get the bell bolts off or will I have to remove the flywheel...
That is disappointing news. Not surprising news either. This is my first transmission pull, and my first time removing the clutch also... I have...
A gantry is a good idea, especially since I am working outdoors on a piece of plywood. I might try "swinging" it into place. Actually had a...
Got the cover off, trans reads 13-07-097-901 T15?
I misread someones post regarding trans removal, I guess they removed the floorboards to gain easier access to the linkage and shifter cover. I...
Thanks nickmil, This Jeeps is a bitsy, but the vin is for a '66 so i have been posting here! Unfortunately, the original floor has been rock...
Is the T15 the only jeep transmission that is 10" long? I had to deduce that I have a T15 from its length since it is still in the jeep and I...
I am looking at a used 44 with power lock for the rear offered by a member of my local 4x4 club. What should I expect to pay for a used setup like...
Separate names with a comma.