That would be wonderful, I'll send you a PM.
Hello all, The turn signals were acting up in my 75 CJ5. Did some searching and decided to disassemble and clean out the Sparton turn signal and...
sparton ts
That jeep up here would be at least a $3500 rig, if not more. No cancer with original paint is unheard of in the NW. But if it's not what you want...
I definitely married a keeper. Pickles is a great an unique name. :) I'm going to have to take the just drive it advise and hopefully a great name...
My wife likes my CJ5 so much that she had to have one too. After a fair amount of unsuccessful searching we took a break from the hunt. While...
My 75 had the tank set up under the seat and I took it out. x2 on the fuel smell plus it stuck out about 6 inches past the seat on the floor...
Went through this conversion 6 years ago. I picked up a donor 82' Dana 30 with the 2 bolt caliper set up. I took the knuckles and calipers off of...
For the roller bearing. Check applied industrial technologies. They have been able to get all kinds of odd bearings that I've needed in the past.
Mr. Gasket makes a good header gasket for the 304. Definitely follow the advise of Thorwon, Check the header to make sure the surface is still...
Is it a replacement from crown? I had the same issues and ended up returning it and fixing the one that was in my tank. :(
I bought a Crown OEM replacement for 75. It worked so-so and it burn out after a couple of wheeling trips. But I have bad luck with anything...
I'd check the bearing sizes inside the bearing hub. They might be different. I know that they were when I did my swap.
4WD had a End of the year sale, got them for 20% off and had em shipped to the store in portland to get free shipping. Only complaintwas the 2 1/2...
I would have to say that the MC2100 works very well with my 304. It provides more than enough power for the mild wheeling that I do. As for...
So, I just put new headers on my Jeep Monday, and it has the gasketless ball-socket ends. Has anyone used these before. I'm a little skeptical...
Funny timing. Just installed headers monday and had this happen to my dipstick :o) Great Info. Thanky
Question for you guys. I did the same thing mentioned above, swapped to 2 bolt caliper disk brakes and pulled the residual valve out of my master...
Yep, bearing hub. Thought they were spindles, but I'm a technical lingo dunce.R)
The residual valve is inside the master cylinder where the line goes out to the porportioning valve. Find the line for the front brakes, (think...
Separate names with a comma.