ok so i have a 1955 cj5, serial number: 57548 23637. way back when it was bought in 12/23/55. but on the title, it says its a 1956. it is the...
i am going to ditch the oil bath air cleaner, but am replacing it with a k&n air filter. has anyone done this before? or better yet have a...
hello, i would like to jet my carb to run at 4300-6000 ft above sea level. i know that it has a main jet, metering rod, and slow jet. does...
hello i am trying to set the preload on the outer bearings. they are all new, and i am trying to get a starting point. thanks josh
i say drive it till something breaks dont start ripping stuff off until the parts are at your door draw or take a picture before you...
also torque the bottom king pin to 35 ft-lb i think... and put the shims at the top of the knuckle to set pre-load
i have a used e-brake drum you can have for shipping cost. i will even throw in a rag or two for the dust, grease...pm me for pictures.
thanks a bunch, i need the help! here is what i was looking for http://www.vernco.com/brakes/id727.htm
hello im in the process of getting parts and getting ready to blitz my jeep. my question is i recall an article about upgrading the cap on a...
thanks for the reply, i will reward you with major pictures soon... oh its in my build section coming soon!!
does anyone know a place to buy upper and lower return springs for my jeep? thanks josh i have looked at kaisers and vintage jeep parts...
there is a nut holding it to the gear, to the mainshaft spline, if you pop the circle plate off the back of the transfer case, it has five bolts...
ive always been told that the smaller dia. the more torque, the larger the better horsepower. if it were me id go with a baffle type muffler,...
did you remove the overdrive gear? pop the circle plate off the back, four bolts, and that big cog will be looking right at you. the gear i am...
no man, just a bunch of motorcycle part boxes, i just got done with my cr500 project
i know this sounds cheesy, but ive had my jeep for about a year indoors, and have not touched it till now. what has held me back, i swear, is that...
if the tank is low with gas, and its real cold, it could condensate, causing water to sink to the bottom. try some "fuel dryer" i forget the name....
Re: Where's My VIN? (New VIN Project, Please Help Out) 1. id plate 57548 23637 motor code 4J10 2995 2. i dont know where to look 3. says on the...
im not trying to jack the thread, but what would the benifets of running 9inch drums around, and a propornishing valve (sp?) what are the...
Separate names with a comma.