My steele brake line has developed a leak near the master cylinder. Is there a braided stainless option to replace the rigid bent steele? Thanks
I'm looking for plans, drawings, measurments, etc. for a rear bumper with swing out tire carrier to fit my 1975. I've been searching the web...
Does anybody still make "original" fender flares? Way back when (1970s) my Jeep had molded rubber fender flares. The only replacements that I've...
I'm thinking about adding Renegade stripes kit to my 1975 - which style would be correct for April 1975?
When airning down for the trail, how low can I go without the risk of loosing tire bead? I'm running 31x10.50x15s on factory Renegade aluminum...
I purchased a polyethylene gas tank for my 1975 a couple of years ago. Unfortunately, the float and tube are too long to fit into the tank. Any...
Rally Tops is currently working on a prototype to start production on a fiberglass CJ5 Top! They are working on 1976 and later to begin with....
My Acme fiberglass top was delivered today.... I've found a write up about re-finishing (this one needs it) but nothing on installation. Any...
My boss just upgraded the stereo in his boat and gave me his stereo and marine speakers. I mounted the speakers in a couple of .30 cal ammo...
If I were to put a tow bar on the front of my CJ, how far could it safely be towed?
Okay, I finally broke down and purchased a DUI ignition/distributor. What is the best way to wire this with minimal effort/disruption of...
On my 75, 258, I have the stock ignition control module, electronic distributor and coil. How much difference would converting to an HEI...
I just got a factory tach (thanks wroughtwhang) and I'm having a little trouble figuring out how to connect it to the existing wiring. I assumed...
Okay...here's the deal. While cleaning the garage, I came across a metal tag that was attached to the transmission/transfer case. Could someone...
What do I need to do to calibrate my speedo for my 31" tires??? I believe the originals (H78/15) were about 28" diameter.
Where's the best deal (price/quality) to purchase sheet metal? I'm in despirate need of new floor boards and rocker panels (where floor meets...
I think I am needing to replace my electronic ignition control module. Anybody know what brand/model would be a direct replacement? I'm...
I've inspected my steering components to my best ability (limited) but there is some "slop" in it that I can't seem to find. The steering shaft...
My wife is getting me a tach for Christmas.... Was the original 6,000 or 8,000 RPM? I can't find in the FSM what max RPM is or "redline"...
Iv'e been driving this CJ for a long time - but the recent snow and ice combination has once again raised the question.... What's the best way...
Separate names with a comma.