I think my low idle screw is missing on my carb linkage. Looks like there is a wide open throttle adjustment on the driver side but on the other...
Thanks
I pulled some axles tonite and I'm not sure which one to put back in. The one that came out of my jeep has smashed threads on the end so would...
Well I got the drivers side torqued and pinned. Just filed the back of the nut a little to let me make the torque setting. After reading all your...
When I left work tonite I noticed some oil on my axle nut. I kicked it and it moved! I could turn it with my fingers. When I got home I looked up...
I couldn't find the procedure in the manual either. #1 cylinder to tdc compression stroke, set #1 cylinder. turn engine 180 degrees, set #2...
I did a search on poly tanks and it looks like they come with they're own problems. No perfect solution I guess.
I sandblasted and painted mine about three years ago with the rest of the jeep. I'm patching it for the second or third time. I think some of the...
Has anyone taken a new gas tank (under seat) and had it Rhino lined or coated. Seems like a good idea but wondering if I'm overlooking something.
Is there a spec for how much tilt or lean you can have between the rocker and the tube?
Hey all, I,m checking a noisey valve train and while adjusting intake valves I found that if I set clearance to .018 on a couple of the valves I...
Thanks Guys. I think I'll order some gaskets and check them one more time.
How often do you adjust your valves? I know the FSM says every thousand miles but wanted to see how often you actually do it. I've got about 2400...
I filed both levers just until they were flat again and got some stainless bushings (Fender washers) from Tractor Supply. I think I got one...
Thanks guys. I filed -both- slots in the plate and got all I needed. :) Didn't want to move the pump in case I ever have to go back to points.
I don't remember if the block side is slotted or not, I'll check that . Did a search and I'm prolly going to have to reset the pump if I can't...
Well now that you mention it there is no gear on the dist it's on the pump. Maybe I'll just have to lengthen the adjustment slot on the mount?
Hey guys I finally got my distributor and module back from Pertronix for the 134. It started right up this time!! When I hooked up the timing...
Thanks I think if I can get them for cheap I'll pick them up this weekend.
The pinion bearings in my front have alot of play so this would be something to drive on while I,m busy messing up mine. I'd just change the...
Separate names with a comma.