Both my 2A's are 6 Volt as they came that way. I did get a 6 volt alternator for one of them.
I am looking for info and pics of dual wheel adapters for an article I would like to post here and on other Jeep sites.
I am going to use these [IMG]
Do a search on the CJ2A forum and you will find a lot of info.
I did the swap you mentioned. I found the 10" self adjustors on the front axle of a 60's Jeepster.
Eventually they will be back but the tires will be made in China.
If you go to the last page of the Holbrook site they give some dimensions that could be helpful.
The dash is structural so an overlay makes more sense. I completely removed a hacked up one by drilling out all of the spot welds and welding in...
http://www.earlycj5.com/technical/springs-and-shocks/earlyintermediate-cj-5-to-wrangleryj-spring-conversion/...
Use Herms bracket but the MC he sold we was way too big, just buy his bracket Cardone has a smaller one that will fit and then use 90 degree banjo...
Check out the wanted section of the CJ2A forum. I am sure there are a lot of them around to be had cheap. $8 to $12 on Epay
I ordered the steel today for the YJ rocker guards. They found a "drop" so I didn't have to buy a full sheet of 1/4" plate. They are going to...
I AM GOING TO PUT SOME ON MY YJ. Very simple, 16" wide sheet of 1/4 inch steel plate the length from wheel well to wheel well. I will have the...
[IMG]
I scored a Warn Overdrive from a Willys truck as well as the tranny and T case. The tooth count was wrong to use on the CJ2A. But someone on the...
Put it where you want it. Move it down the road. Although OD levers may all be in the same spot, PTO levers vary greatly.
I was ready to go Saginaw and had the bracket and box. Then I acquired a PTO winch so I bought a Willys Overland France stock box and stayed...
I have wondered why Willys went from an electric/manual (foot pedal button connects a 6 volt wire to the starter) starter to an old fashioned...
...only a mother could love!
Yea, I am not old enough for old school. There is no welding skill involved, you just drop in the tapered insert and tack it around the edge. I...
Separate names with a comma.