angel I am afraid daryl is correct. pull valve cover and you will see a lifter not lifting to its full height. I had the same misfortune with...
maybe you should reinstall the rocker assemblies and cycle the oil pump to verify oil is getting to all parts. running engine without confirming...
As a certified welder and current structural steel and welding inspector here in los angeles, I can say without reservation that the welding on...
late to say thanks for info and clarification. now i can button it up without any reservations. this really a great site!
in a bit of a panic as i am getting ready to button up the 225 after a new camshaft install when i come across a thread showing a camshaft...
If you took say a 3/4 turnbuckle and some cable with clamps or cable chokers and hooked them at the corners of the long dimension, it would be a...
hey matt a good way to look for cracks is to get the suspect area super clean, then apply some baby oil in the area. wipe it clean then...
hey worman a tip of the cap on that design! that is a thing of beauty.
i get a loud whining noise when i need any parts for my jeep. luckily its only my wife!
no doubt the radiator. have a shop take off the top and bottom reservoirs and rod and boil out the core if it can be saved, if not they can put in...
hey cj-jim preperation is everything! use fresh 7018 rod. remove all paint, scale and grease. don't bother with grinding a bevel, the...
hey jayhawkclint what is the thickness of the material you are cutting. if you are using the magnetic drill, material less than 3/8 does'nt...
thanks gents. i like the n.o.s. except the price. will mull it over some before commiting
the speedometer in my '66 cj5 gave up the ghost last week(frozen drive) and looking for a n.o.s. speedo but no luck. lots of omix units for sale...
Separate names with a comma.