Hey Scott, I just walked out and measured my seat brackets on a '69 cj-5 with a tank under the driver seat. From the center of the outside body...
I had to take a 1/2" off the input shaft when I put a t18 in to my '70 v-6. I don't know if you are putting a new tranny in, or the old one that...
Hi, I'm welding up a mount for a ramsey pto on a '71 cj-5. I was woundering if you have a sketch of brackets for your winch? The other "low...
I had a koeing on a my 1970 but did a freelance job on the drive shaft and bearing mount. So If yours is the stock set up I would still love to...
Nice to see you jeepers keeping the old koeing winches alive. I'm installing one on my '71 and would love to see pics of the pto shaft and...
My '70 has the stencil.
I agree, they track much better down the highway. My '70 cj-5 does just fine of road. I had to move it forward a couple of inches. As far as...
I will get you some pic's this weekend. A t-90 was a great tranny in 1965, but this is 2007. A 4 speed is a great up grade. I have a t-90...
I've never seen a aftermarket body as thick as a original. Look for a good stock tub. As far as t-90 behind a v-6 don't waste your time. A sm...
I have '70, '71, and '73 CJ-5's which all have a seperate flasher switch on the dash. The '73 does not have the red lens, just a black knob. I...
Thanks Jim, The odds look slim. I've already wired the jeep for the stock switch. It is a single throw 4 circut push/pull. I think it was...
I'm looking for a stock hazard switch that goes in the dash for a '71 cj-5. I haven't been able to find one aftermarket. Does anyone have one, or...
Anyone have a bop bell housing for sale?
I'm doing the same conversion right now. Which Bell housing are you using? My T-18 is out of a '74 CJ-5 with a straight 6. It has a 7.25" stick...
Separate names with a comma.