does anyone no the width length and height of an early cj hood ?
As it turns out the input shaft of the dodge trans is going to have to be swapped out for a Chevy version, and then I will be able to use a late...
The late nv4500 has a more beefy tail housing and it makes contact with the bearing retainer on the 300 so a ring or spacer is needed .... My...
I already own the dodge version it was too good of a deal to pass up, low miles won't need a rebuild and should mate up to a Dana 300
So I found myself a good deal on a dodge 23 spline nv4500 Has anyone used this transmission with the stock 225 ?
So what year would a vented windshield be found ? I would love to find one that would work with my 66 and Meyer hard top
Any chance you have a diagram for a 66 with a v6
I just like the difference of the short nose, I am going to try my best to keep it that way Once I start building the frame and have the engine...
That's very close, is that a custom rad ? Or did you find a part number somewhere that worked size wise
I will likly go something crate but used, there are a few company's out there that get the engines, do a mild check over of them, build harnesses...
This makes me feel like it's all more doable, do you have any pictures of the grill or firewall ?
I will probably build a whole new chassis
I don't have a year figured out, I guess that is part of my searching, if one year or another is easier then that will be my route to go. As for...
I am thinking about doing an LS swap on my 66 cj6, I have been doing some searching and I have found lots of parts and kits to do it on the later...
Separate names with a comma.
