A buddy and I rebuilt his trans case and still had the vibration. We just couldn't figure it out. Then a friend of ours who had gone blind and...
I watched a Bronco go for a swim once. On the way out of the hole we were in we had to clear a way around it because it was blocking the trail...
All drive train bolts I've seen, including those, are fine thread. Maybe even hardened a bit???? Call one of the old jeep parts outlets. Lots...
You may not need a special tool. Maybe you could find a steel or aluminum rod and beat on one end until it fits in the oil pump shaft slot.
I'm in the middle of a T-14 rebuild. Are you in need of a Main Shaft bearing or a Cluster Gear/Reverse Idler bearing?
Broke out the old Jeep Service Manual. Can't remember a thing from my carb rebuild. If I understand what ball you are refering to, it look like...
May be something to this Timing Chain business. If the timing is several degrees off, your timing chain might have jumped a tooth or two on the...
Good call on the bad ignition coil. I've been had by that one. Also been educated, the hard way, by a bad distributor condenser. Good Luck!
After putting this together I feel like I need to apologize for at least the length and most likely way too much detail..............Sorry! My...
With respect to the brakes......... You upgraded to 11" brake shoes. Were the original wheel cylinders 1 1/8" diameter bore already? Not sure...
Separate names with a comma.
