I got it. To answer your question before I make my confession... The distributor is new and I did bypass the resister with the heavier guage wire...
I've the original wire from the donor vehicle of the distributor. It appears to be 12 awg, yes.
I'm tryin to put an aftermarket hei dist. In my 74 258. It has a skip I can't get out. The distributor is new. Since then I've replaced the plugs,...
No, I've replaced gear box, tie rod ends repacked my wheel bearings, (replace less than 10k miles ago). The whole axle, springs and even shocks...
Well I installed the upper and lower ball joints and new axle u joints. All that work and it still steers like crap. I noticed as my brother in...
Thanks everyone for the advice and instruction. I've got just about everything, just waiting for what I had to order on line.
I've replaced the wheel bearings and races both inner and outer along with the seals for them. I know how to get that far again, are there any...
Does anyone tell me the proper procedure to replace the u joints on the d 30 axle, Mine appear to be wore. One thing is I want to have all the...
I agree with Boyink on the Bestop seats. I put a set in my 5. Took some getting used to with that bar in the back. Not near as comfortable as...
Welcome from Upstate NY
I found my problem last night finally. It was a short where the wire went through the frame heading up to the right rear tail light. Of course...
It's not quite there but I making some headway. Yes it is a GM column. It does have a 4way pull switch, and that works. The horn now works,...
For the record, all the electrical has worked fine for 3 yrs.
Separate names with a comma.