Dana 30 - something missing?

Is there supposed to be a seal or anything here at the axle shaft?

 

No seal in that location.

 

Alright thanks just making sure

 

on some there is a splash shield (made from plastic) and it sits right in that last step before entering the tube. they do make a part that acts like a seal you can get from 4wd.com to keep debris from getting inside the tubes.

 

These were stamped steel parts originally. Most are plastic now. For once Omix-Ada comes through with an original piece. It's called an Inner Axle Dust Shield. http://www.amazon.com/Omix-Ada-16527-04-Axle-Dust-Shield/dp/B000FPXX9U

 

Do any of y'all run anything there or just leave it open?

 

They are there for a reason. They keep the worst of the crap out of your axle housing. Fine sand can still get in but gravel cannot.

 

Normaly you got a seal inside the axle

 

I run the part that was linked above...however, I wouldn't tear down the axle just to put one on. Just be aware of it and check occasionally for any gravel or larger particles that might get stuck.

 

That keeps the gear oil in the carrier, not debris out of the axle tubes


Sent from my iPhone using Tapatalk

 

Yea. Its already apart. I emailed Alloy USA to make sure it would fit an earlier d30. Don't see why it shouldn't.