Seam Roller / St. Louis Area

Anyone around the St. Louis area know of a place that can do a 1/2" radius seam roll on 16,18 or 20 ga rolled steel? Rougly 36" wide (the width of the door). I can't seem to find anyone/sheetmetal fab that has the tools for this.......
I'm replacing my meyer door skin and would like for it to be as close to stock as possible. I guess I could just brake a "V" into it but again I'd like it to be as close to original as possible...
Thanks in Advance!.

 

no idea but... if you take that Harbor Freight coupon and check out their rollers, others may be coming to you for the same service

 

I have thought and looked into that.. but the biggest one they have only has a 12" deep throat.. not quite enough reach..... I on the other had will likely be picking up one of their 36" brakes though....

 

This would be a long shot but you might try Steelweld Equipment in St. Clair. They manufacture service bodies for AT&T and Verizon and have a neat factory. Take I 44 west to the Hwy 47 exit. Continue west on the outer road and it is about 1/2 mile on the right.

The only contact I have there is Steve. I would recommend walking in the front door. They may give you an easy NO over the phone.

Expect to pay since this will be a custom fab for them.